Hyundai Elantra (CN7): Engine Mechanical System / Engine And Transaxle Assembly
Special Service Tools Tool (Number and name) Illustration Use Valve spring compressor(09222-3K000)Valve spring compressor adapter(09222-3K100)Removal and installation of the intake / exhaust valve spring and retainer lockValve stem seal installer(09222-2B100)Installation of the valve stem sealOil pan remover(09215-3C000)Removal of oil panCrankshaft front oil seal installer(0K231-2C200)Installation of the crankshaft front oil sealCrankshaft rear oil seal installer(09231-2B200)Handle(09231-H1100)Installation of the crankshaft rear oil sealRing gear stopper(09231-3N100)(09231-2B100)Removal and installation of crankshaft damper pulley bolt
Repair procedures Removal and Installation1.Remove the engine cover (A).2.Installation is reverse order of removal
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Heater Unit
Components and components location Component Location1. Heater unit assemblyCompoents1. Heater unit assembly2. Heater tube cover3. Heater core assembly4. Mode control actuator [LH]5. Dummy PTC6. Temperature control actuator [LH]7. Heater case [LH]8.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Blower Motor
Repair procedures Inspection1.Connect the battery voltage and check the blower motor rotation.Replacement1.Disconnect the negative (-) battery terminal.2.Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- General Tightening Torque Table. General information
- Function settings
- Vehicle Information
- New on site
- Most important about car
