Hyundai Elantra: Indicators And Gauges / Troubleshooting
Error Item
|
Failure symptom
|
Inspection items
|
Detailed inspections
|
Relevant Parts/
Components
|
Screen display
| TFT-LCD screen does not turn on
| | 1) | Check the connector attachments |
2) | Check B+, IGN and GND wiring |
| Connectors, wiring, fuses, dashboard
|
Warning light
| Airbag warning lamp malfunction
| | 1) | Check airbag + signal (connectors) |
2) | Check C-CAN (ACU4) signal |
3) | Check the FPC attachment inside the dashboard |
| ACU Connectors, wiring, fuses, dashboard
|
Mode conversion
| Integrated driving mode malfunction
| | 1) | Check the switch input (connector) |
2) | Check the switch signal input (disconnection or shorting) |
3) | Check conversion with dashboard component |
| Switch connector, wiring dashboard
|
Illumination
| Interior light brightness cannot be controlled.
| | 1) | Check if the light switch's input signal reaches the connector |
2) | Check ILL- and DETENT signals |
3) | Check the TAIL+ signal input |
| Switch connector, wiring dashboard
|
Warning Sound
| No dashboard alarm
| | 1) | Check the speaker output connector |
| Speaker connectors, wiring dashboard
|
Fuel indicator
| Faulty fuel gauge indication
| | 1) | Check fuel input and GND connectors (open, short or input resistance values) |
| Fuel sender connector, wiring dashboard
|
Description and operation
Description Abbreviation Expalnation ACUAirbag Control UnitADMAssist Door ModuleB_CANBody Controller Area NetworkBCMBody Control ModuleBCWBlind-Spot Collision WarningC_CANChassis Controller Area NetworkCLUCluster ModuleDATCDual Automatic Temp ControlDDMDriver Door ModuleESCElectronic Stability ProgramEMSEngine Ma..
Other information:
Operates as follows when the ignition
switch is in the ON position.
MIST: For a single wiping cycle, push
the lever upward and release. The
wipers will operate continuously if
the lever is held in this position.
OFF: Wiper is not in operation.
INT: Wiper operates intermittently at
the same wiping intervals. To vary
the speed setting, move the speed
control lever. The top most setting
will ..
In the OFF position, pull the lever gently
toward you to spray washer fluid on the
windshield and to run the wipers 1-3
cycles. The spray and wiper operation
will continue until you release the lever. If
the washer does not work, you may need
to add washer fluid to the washer fluid
reservoir.
WARNING
When the outside temperature is below
freezing, ALWAYS warm the windshield
using the def..