Hyundai Elantra: Wireless Power Charger System / Troubleshooting

Hyundai Elantra (CN7) 2021-2025 Service Manual / Body Electrical System / Wireless Power Charger System / Troubleshooting

Troubleshooting

Wireless Power Charger System Troubleshooting

Trouble status	Inspection item	Inspection
Not charged	Check the mobile phone status	R-1
Amber LED blinks	Overcurrent	R-2
	Overheating	R-2
	Foreign matter	R-2

R-1. Check the wireless power charger system operation

If the placement of a mobile phone is not detected

(1)

If the internal temperature of the mobile phone battery is high, the mobile phone itself turns "OFF" the power.

The temperature at which the power is automatically turned "OFF" differs by mobile phone model.

(2)	If the mobile phone was placed outside the charging range

(3)	If the mobile phone was placed by its LCD side on the charging pad surface (if the phone was placed upside down)

(4)	If the mobile phone was turned 180°

2.	Check that the amber LED of the wireless charging lamp turns on when the mobile phone is in normal condition and is correctly placed.

R-2. Check for overcurrent, overheating and foreign matter

Overcurrent : Charging stops in overcurrent of over 4.5 A

(1)	The overcurrent error status will be reset when the current falls under 4.5 A or when ACC is turned off and on.

Overheating : The unit will be automatically turned "OFF" when the internal temperature of the wireless charging unit is over 158°F (70°C).

(1)	The error status will be reset when the internal temperature of the wirelss charging unit falls under 149°F (65°C).

Foreign matter : When metallic objects such as coins, clips and precious metals are detected, charging will be stopped to prevent overheating.

(1)	Error status will be reset when foreign matter is removed.

•	The amber LED of the charging display lamp blinks 10 times for 10 seconds, and then it is turned off for 50 seconds (total 60 seconds).

•	The process is repeated for every 60 seconds.

•	Turning ACC OFF/ON resets the error status and returns to normal operation.

Specification

Specifications Item Specification Rated voltageDC 12VOperating voltageDC 9.0 - 16.0VOperating temperature-86 to 167°F (-30 to 75°C)Dark currentMAX 1mAOutput power5 WOutput frequency110 ± 5 kHz..

Other information:

Hyundai Elantra (CN7) 2021-2025 Service Manual: MDPS Wiring

Repair procedures Removal • For DTC C125901 / C125929 / C125938 / C129002, refer to "CN7 MDPS DTC Diagnostic Guide".1.Turn the ignition switch OFF and disconnect the battery negative (-) cable. • Disconnect the battery negative cable from the battery and then wait for at least 3 minutes.2.Remove the fuse cover..

Hyundai Elantra (CN7) 2021-2025 Owner's Manual: Instrument Panel Fuse Replacement

1. Turn the vehicle off. 2. Turn all other switches OFF. 3. Open the fuse panel cover. 4. Refer to the label on the inside of the fuse panel cover to locate the suspected fuse location. 5. Pull the suspected fuse straight out. Use the removal tool provided in the engine compartment fuse panel. 6. Check the removed fuse; replace it if it is blown. Spare fuses are provided in the engine comp..

Tilting the sunroof

Tilt the sunroof open:

Push the sunroof control lever upward until the sunroof moves to the desired position.

To close the sunroof:

Press the sunroof lever forward until the sunroof moves to the desired position.