Hyundai Elantra (CN7): Heating, Ventilation and Air Conditioning / Blower
- Blower Unit
- Blower Motor
- Power Mosfet
- Blower Resistor (Manual)
- Climate Control Air Filter
- Intake Actuator
Description and operation DescriptionThe auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging.
Components and components location Component Location1. Blower unit assemblyComponents1. Blower unit assebmly2. Blower upper cover [LH]3. Duct seal4.
Other information:
Hyundai Elantra (CN7) 2021-2025 Service Manual: Receiver-Drier
Repair procedures Replacement1.Remove the condenser.2.Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft) 3.Remove the receiver-drier (A) from condenser using a long nose plier.
Hyundai Elantra (CN7) 2021-2025 Service Manual: Intake Actuator
Description and operation DescriptionThe intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes. Components and components location Components Location1.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- Heating, Ventilation and Air Conditioning
- Rear Seats
- Integrated Thermal Management Module (ITM)
- New on site
- Most important about car
