Hyundai Elantra (CN7): Warning and Indicator Lights / High Beam Indicator Light
This indicator light illuminates:
- When the headlights are on and in the high beam position.
- When the turn signal lever is pulled into the Flash-to-Pass position.
This warning light illuminates: • When you set the Engine Start/Stop button to the ON position. -- The LED headlight warning light illuminates for approximately 3 seconds and then goes off.
This indicator light illuminates: When the tail lights or headlamps are on.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Blower Resistor (Manual)
Repair procedures Inspection1.Measure the resistance between the terminals.2.The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)Replacement1.Disconnect the negative (-) battery terminal.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Rear Corner Radar Unit
Specifications Specifications Items Blind-Spot Collision Warning (BCW) Blind-Spot Collision- Avoidance Assist-Rear (BCA-R) Rated voltageDC 12VOperating voltage9V - 16VOperating speed30 km/h - 255 km/h60 km/h - 180 km/hSensible distance70m Curvature radiusStart : More
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- Driver assistance system
- Components and components location
- General Tightening Torque Table. General information
- New on site
- Most important about car
