Hyundai Elantra (CN7): Suspension System / Rear Suspension System
Repair procedures Removal[A type]1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.2.Remove the front wheel and tire (A) from the front hub.
Components 1. Rear torsion beam axle2. Rear torsion beam chassis bracket3. Rear axle
Other information:
Hyundai Elantra (CN7) 2021-2025 Service Manual: Condenser
Components and components location Components Location[General type]1. Condenser[N Line]1. Condenser Repair procedures Inspection1.Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air.
Hyundai Elantra (CN7) 2021-2025 Service Manual: Blower Resistor (Manual)
Repair procedures Inspection1.Measure the resistance between the terminals.2.The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)Replacement1.Disconnect the negative (-) battery terminal.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- Manual Transaxle System
- Clutch System
- LCD Display Messages
- New on site
- Most important about car
