| Specification |
|
Item
|
Type
|
Bulb Watt (W)
| |||
| Front | Head lamp | Halogen | Low beam / High beam | 9005L+ | 60 |
| DRL/Position lamp | LED | LED | |||
| LED | Low beam | LED | LED | ||
| High beam | LED | LED | |||
| DRL/Position lamp | LED | LED | |||
| Turn signal lamp | PY21W | 21 | |||
| Door mirror turn signal lamp | LED | LED | |||
| Rear | Rear combination | Halogen | Tail lamp | W5W | 5 |
| Tail / Stop lamp | P21/5W | 21 / 5 | |||
| Back up lamp | W 16W | 16 | |||
| Turn signal lamp | PY 21W | 21 | |||
| LED | Tail / Stop lamp | LED | LED | ||
| Back up lamp | W 16W | 16 | |||
| Turn signal lamp | PY21W | 21 | |||
| Back up lamp | PY21W | 21 | |||
| LED | LED | ||||
| License plate lamp | W5W | 5 | |||
| Interior | Map lamp | Sunroof not applied | W10W | 10 | |
| Sunroof applied | W10 | 10 | |||
| Room lamp | FESTOON | 8 | |||
| Luggage lamp | FESTOON | 5 | |||
| Vanity lamp | FESTOON | 5 | |||
Component Location1. High/Low beam2. Low beam3. High beam4. Position lamp&DRL5. Front turn signal lamp6. Map lamp7. Vanity lamp1. Stop lamp2. Turn signal lamp3.
Repair procedures Head Lamp Aiming Instructions[Mechanical Aiming]The head lamps should be aimed with the proper beam-setting equipment, and in accordance with the equipment manufacturer's instructions.
Repair procedures Oil Specification1.The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed.2.Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor.
Repair procedures Inspection1.Measure the resistance between the terminals.2.The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)Replacement1.Disconnect the negative (-) battery terminal.