Hyundai Elantra: Auto Lighting Control System / Description and operation

Hyundai Elantra (CN7) 2021-2025 Service Manual / Body Electrical System / Auto Lighting Control System / Description and operation

Description

It's a system that uses illumination sensor to automatically turn ON the tail lamp and head lamp based on the change in surrounding environment's illumination condition. It activates when the vehicle enters/exits tunnel, or when the illumination condition in surrounding environment changes due to rain, snow, or fog. Precautions corresponding to the use of this system are as follows.

1.	Do not add another device on top of this device.

2.	Be sure to switch to manual during poor visibility climate, such as fog, heavy rain, or cloudy weather.

3.	Illumination intensity in an actual vehicle is not always constant, and lamp ON/OFF time may very depending on the climate, season, and surrounding environment.

4.	Use this system only during sunrise and sunset period, and manually control lamp ON/OFF for general conditions.

5.	Error may occur if light block coating that may change interior illumination is applied.

Auto Lighting Control System

Components and components location

Component Location1. Auto light sensor2. Head lamps3. Lighting switch (Auto)4. Rear combination lamps5. Integrated body control unit (IBU)..

Other information:

Hyundai Elantra (CN7) 2021-2025 Owner's Manual: Hazard Warning Flasher

The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle. It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway. To turn the hazard warning flasher on or off, press the hazard warning flasher button. The button is located in the center f..

Hyundai Elantra (CN7) 2021-2025 Service Manual: Rear Mud Guard

Repair procedures Replacement • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Put on gloves to prevent hand injuries.1.After loosening the mounting screws and remove the rear mud guard (A).2.To install, reverse the removal procedure. ..

Tachometer

The tachometer indicates the approximate number of engine revolutions per minute (RPM).

Use the tachometer to select the correct shift points and to prevent lugging and/ or over-revving the engine.

NOTICE

Do not operate the engine within the tachometer's RED ZONE. This may cause severe engine damage.