Hyundai Elantra (CN7): Engine Mechanical System
- Specifications
- Repair procedures
- Troubleshooting
- Special service tools
- Engine And Transaxle Assembly
- Drive Belt System
- Timing System
- Cylinder Head Assembly
- Cylinder Block
- Cooling System
- Components and components location
- Troubleshooting
- Coolant
- Coolant Reservoir Tank
- Cooling Fan
- Radiator
- Integrated Thermal Management Module (ITM)
- Water Inlet Fitting
- Water pump
- Lubrication System
- Components and components location
- Flow diagram
- Engine Oil
- Oil Pan
- Oil Filter & Oil Cooler
- Oil Pump
- Oil Pressure Control Solenoid Valve
- Intake And Exhaust System
General information General Service Information Protection of the Vehicle Always be sure to cover fenders, seats, and floor areas prior to beginning work.
Specifications Description Specifications Limit General TypeIn-line, DOHC 　Number of cylinders4 　Bore75.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: High Mounted Stop Lamp
Repair procedures Removal1.Disconnect the negative (-) battery terminal.2.Remove the rear package tray trim.(Refer to Body - "Rear Package Tray Trim")3.Loosen the mounting screws and remove the high mounted stop lamp (A).Installation1.Install the high mounted stop lamp.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Temperature Control Actuator
Description and operation DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- Rear Seats
- Specifications
- Auto Hold. Warning messages
- New on site
- Most important about car
