Hyundai Elantra (CN7): Brake System / Brake System
- Repair procedures
- Brake Booster
- Master Cylinder
- Brake Line
- Brake oil
- Rear Disc Brake
- Brake Pad
- Stop Lamp Switch
Brake System BleedingNomal Brake System • Do not reuse the drained fluid.• Always use genuine DOT4 brake Fluid.
Operation and Leakage Check Component Procedure Brake Booster (A)Apply the brake and check its operation during the test run.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Rear Combination Lamp
Repair procedures RemovalOutside Combination Lamp1.Disconnect the negative (-) battery terminal.2.Remove the combination lamp cover (A).3.Disconnect the rear combination lamp connector (A).4.Loosen the mounting nuts and remove the rear conbination lamp (A).
Hyundai Elantra (CN7) 2021-2026 Service Manual: Mode Control Actuator
Description and operation DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- Drive Mode
- Integrated Thermal Management Module (ITM)
- Engine Mechanical System
- New on site
- Most important about car
