Hyundai Elantra (CN7): Accessing Your Vehicle / Smart Key
Your HYUNDAI uses a smart key, which you can use to lock or unlock a door (and trunk) and even start the engine even just carrying the key.
(1) Door Lock
(2) Door Unlock
(3) Trunk Open
(4) Panic
(5) Remote Start
- Locking your vehicle (Button type)
- Locking your vehicle (Touch sensor type)
- Unlocking your vehicle (When the Two Press Unlock feature is off)
- Unlocking your vehicle (When the Two Press Unlock feature is on)
- Trunk opening & Panic button
- Remote start
- Start-up
- Mechanical key
- Loss of a smart key & Smart key precautions
- Battery replacement
If the remote key is not working properly, try replacing the battery with a new one. Battery Type: CR2032 To replace the battery: 1. Insert a slim tool into the slot and gently pry open the cover.
1. Close all doors, engine hood and trunk. 2. Carry the smart key. 3. Either press the door handle button or press the Door Lock button (1) on the smart key.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Blower Resistor (Manual)
Repair procedures Inspection1.Measure the resistance between the terminals.2.The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)Replacement1.Disconnect the negative (-) battery terminal.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Intake Actuator
Description and operation DescriptionThe intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes. Components and components location Components Location1.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- General Tightening Torque Table. General information
- Suspension System
- Front Radar Unit
- New on site
- Most important about car
