Hyundai Elantra (CN7): Engine Mechanical System / Cooling System
- Components and components location
- Troubleshooting
- Coolant
- Coolant Reservoir Tank
- Cooling Fan
- Radiator
- Integrated Thermal Management Module (ITM)
- Water Inlet Fitting
- Water pump
Repair procedures Disassembly • Use fender covers to avoid damaging painted surfaces.• To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
Components1. Water pipe2. Water hose3. Integrated thermal management module (ITM)4. Heater pipe5. Turbo charger coolant hose6. Heater hose7. Heater pipe A8.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Antenna Coil
Repair procedures Removal1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")3.Remove the steering column shroud panel.(Refer to Body - "Steering Column Shroud Panel")4.Disconnect the immobilizer connector (A) and press the locking pin (B) using an awl.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Receiver-Drier
Repair procedures Replacement1.Remove the condenser.2.Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft) 3.Remove the receiver-drier (A) from condenser using a long nose plier.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- General Tightening Torque Table. General information
- Auto Hold. Warning messages
- Instrument Panel Overview
- New on site
- Most important about car
