Hyundai Elantra (CN7): DCT(Dual Clutch Transmission) System / Dual Clutch Transmission Control System
- Description and operation
- DCT Control Module (TCM)
- Clutch Actuator & TCM Assembly
- Gear Actuator Assembly
- Input Speed Sensor
- Inhibitor Switch
- Shift Lever
- Shift Cable
General information General Information1.Check & Change intervals Check & Replenishmen Change Capacity Oil specification Normal Use Severe Use No check No service required120000 km(80000 miles)1.
DescriptionThe Dual Clutch Transmission (DCT) control system measures required data to identify the state of the control target and computes the appropriate compensation value if adjustment is necessary.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Rear Combination Lamp
Repair procedures RemovalOutside Combination Lamp1.Disconnect the negative (-) battery terminal.2.Remove the combination lamp cover (A).3.Disconnect the rear combination lamp connector (A).4.Loosen the mounting nuts and remove the rear conbination lamp (A).
Hyundai Elantra (CN7) 2021-2026 Service Manual: Intake Actuator
Description and operation DescriptionThe intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes. Components and components location Components Location1.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- Vehicle Information
- Driver assistance system
- Front Radar Unit
- New on site
- Most important about car
