Hyundai Elantra (CN7): Driveshaft and axle
- Troubleshooting
- Specifications
- Special service tools
- Front Axle Assembly. Front Hub / Knuckle / Tone Wheel
- Driveshaft Assembly
- Rear Axle Assembly. Rear Hub - Carrier
Components and components location Components1. Engagement bearing sleeve2. Clutch engagement fork3. Engagement bearing 1 (Odd)4. Engagement bearing 2 (Even)5.
Troubleshooting Symptom Expected cause Countermeasure Leaning phenomenon of vehicleDefect on front suspension and steering.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Head Lamp Leveling Device
Components and components location Component Location1. Head lamp leveling actuator2. Head lamp leveling switch Head Lamp Leveling Switch Schematic diagrams Schematic Diagrams Repair procedures Replacement1.Disconnect the negative (-) battery terminal.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Mode Control Actuator
Description and operation DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- Engine Control / Fuel System
- Vehicle Information
- Front Radar Unit
- New on site
- Most important about car
