Hyundai Elantra (CN7): Body (Interior and Exterior) / Interior Trim
- Components and components location
- Door Scuff Trim
- Cowl Side Trim
- Front Pillar Trim
- Center Pillar Trim
- Rear Pillar Trim
- Rear Wheel House Trim
- Rear Package Tray Trim
- Rear Transverse Trim
- Luggage Side Trim
Components and components location Components[General Type]1 . Roof trim 2 . Sunvisor [LH] 3. Sunvisor [RH] 4. Assist handle bracket[Sunroof Type]1 . Roof trim 2 .
Components1. Cowl side trim 2. Front door scuff trim 3. Rear door scuff trim 4. Front pillar trim 5. Center pillar upper trim 6. Center pillar lower trim 7.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Receiver-Drier
Repair procedures Replacement1.Remove the condenser.2.Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft) 3.Remove the receiver-drier (A) from condenser using a long nose plier.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Mode Control Actuator
Description and operation DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- Towing
- Brake System
- Maintenance
- New on site
- Most important about car
