Hyundai Elantra (CN7): Body (Interior and Exterior) / Crash Pad
- Components and components location
- Cluster Fascia Side Panel
- Cluster Fascia Panel
- Crash Pad Garnish
- Crash Pad Lower Panel
- Glove Box
- Glove Box Housing Cover
- Steering Column Shroud Panel
- Crash Pad Air Vent
- Crash Pad Side Cover
- Crash Pad Center Panel
- Main Crash Pad Assembly
- Cowl Cross Bar Assembly
Components and components location Component Location [This illustration shows the LHD type. RHD type is symmetrical.]1. Console armrest Repair procedures Replacement • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Components[This illustration shows the LHD type. RHD type is symmetrical.]1. Crash pad assembly2. Crash pad lower panel3. Crash pad side cover [LH]4. Crash pad side cover [RH]
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Antenna Coil
Repair procedures Removal1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")3.Remove the steering column shroud panel.(Refer to Body - "Steering Column Shroud Panel")4.Disconnect the immobilizer connector (A) and press the locking pin (B) using an awl.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Heater Control Unit
Components and components location Component Location1. Heater control unitComponents[Connector A] Pin No Function Pin No Function 1Mode control actuator (Feedback)21Mode control actuator (Vent)2Intake actuator (Feedback)22Mode control actu
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- Body Electrical System
- General Tightening Torque Table. General information
- Instrument Cluster
- New on site
- Most important about car
