Hyundai Elantra (CN7): Steering System

Description and operation DescriptionTPMS Receiver : BCM(body control module) integrated management1.Early state• Platform information and sensor ID are not input.

Troubleshooting Symptom Probable cause Remedy play in steeringLoose yoke plugRetightenLoose steering gear mounting boltsRetightenLoose or worn tie rod endRetighten or replace as necessarySteering wheel does not return properlyExcessive turning resistance of tie rod endReplaceYoke plug excessively tightAdjustTie rod and/or ball joint cannot turn smoothlyReplaceLoose mounting of gear box mounting bracket Worn steering shaft joint and/orRetightenWorn steering shaft joint and/or body grommetCorrect or replaceDistorted rackReplaceDamaged pinion bearingReplaceRattling or chucking noise in the rack and pinionInterference with hoses from vehicle bodyRepositionLoose gear box bracketRetightenLoose tie rod end and/or ball jointRetightenWorn tie rod and/or ball jointRetighten

Other information:

Hyundai Elantra (CN7) 2021-2026 Service Manual: Rear Combination Lamp

Repair procedures RemovalOutside Combination Lamp1.Disconnect the negative (-) battery terminal.2.Remove the combination lamp cover (A).3.Disconnect the rear combination lamp connector (A).4.Loosen the mounting nuts and remove the rear conbination lamp (A).

Hyundai Elantra (CN7) 2021-2026 Service Manual: Temperature Control Actuator

Description and operation DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

Categories

 
Copyright © 2026 www.helantra7.com - 0.0271